1. Open the mehcanical seal, and throw away the following components: carbon/graphite surface.Elastomer and seal;Spring;Fixed screw;Any drive ear or resistance to rotate the pin;Broken or damaged bellows;The mechanical seals side of cracks or breakage.

2. Review and solve corrosion of each component of the friction and wear and tear or damage.

3. Clean the remaining parts, such as sleeve, adapter, etc.

4. Check the cleaning changzhou Wu Ying hot oil pump parts, to ensure that their original size, the tolerance, finish.

5. Some metal carbon fiber composite material, must eliminate the stress, remove the pressure of the finished goods after assembly, will prevent the remaining plane carbon during storage and transportation.If you intend to carbon insert a metal stents, you will be better for him to shaft joint.

6. Check the mechanical sealing assembly of flatness.Vacuum check should be active components, to ensure that wujin heat conduction oil pump without any leakage around the path or any component.If you choose to check ink cartridges installed double sealed air test, avoid soaking in the water seal.If seal installed behind the hot oil or similar application of water trapped in the gasket and small cracks will flash steam pressure possible danger.

7. Only use has been provided by the manufacturer new parts to assemble the components.Sure to use only original equipment parts, because many seals manufacturer had gone from "finite element analysis" or a similar technique to create component design.Solid-state drives face can, if they don't damaged in any manner.Plating or coating must be splitting and back ground before plating.

Service Hotline: 4008809944